Heatsink Extrusion 10.1
Total length: 10.0"
This is a massive heatsink which works fantastic for the highest power DRSSTC Tesla Coils. This heatsink is used in our Reference Design 3.0 Tesla Coil and allows for the mounting of four (4) large CM600HA-24H IGBTs in a full-bridge configuration. There is enough room on the heatsink to also install ground screws, shunt filter capacitors, and a high current rectifier module. The fins on this heatsink are nearly 3" high providing substantial cooling.
This heatsink is also available fully machined with tapped holes for mounting four (4) CM600HA-24H IGBTs, and high current rectifier module as well as several ground terminals.
Click here for the datasheet (PDF)
Please note the photo above shows an arbitrary length of this heatsink.