Machined Reference Design 1.0 Heatsink
This is a fully machined heatsink assembly for use in our Reference Design 1.0 Tesla Coil. It has tapped holes for a single CM300DY-12NF IGBT module, a bridge rectifier module, two (2) ground terminals for grounding connections and primary shunt capacitor connection, and also two 10-32 mounting holes on the bottom of the heatink.
Mounting hardware is included with this heatsink assembly.
Heatsink Extrusion 5.4 x 5" Length
Click here for the heatsink extrusion datasheet (PDF)
Please note components are not included with this heatsink.